NEW JERSEY OVERSIZE PERMITS INFORMATION
We are not a permit service. We do not arrange permits for carriers. The following is for informational purposes only. We also do not answer permit and escort requirements. Always read your permits and provisions sheets carefully. We cannot guarantee the accuracy of the information provided.
New Jersey DOT Ph#: 609-963-2085
PERMITS: New Jersey oversize permits are valid for five travel days. Must have permit prior to entering the state.
OPERATING TIME: Daylight hours seven days a week. Overweight only are not restricted for travel time.
RESTRICTED TRAVEL: No travel on major holidays. No travel on NJ Route 495 and the Holland Tunnel, New Jersey Turnpike, Garden State Parkway and the Atlantic City Expressway. Access onto the I-95 section of the NJ Turnpike between Ridgefield and the George Washington Bridge (mp118 to mp 122) is only obtainable with permission of the Turnpike Authority, phone (732) 247-0900, extension 5429. Vehicles traveling I-95 to New York via the GW Bridge must contact Patrick C. Kennedy Traffic Safety Officer of the NJ/NY Port Authority prior to arrival, phone (201) 242-8116.
- 53′ semi-trailer on Interstate and designated highways (41′ kingpin to center of rear tandem)
- 48′ on all other roads
- 8′-6″ on designated roads
- 8′ all other roads
Weight: 80,000 Gross
- Single – 22,400
- Tandem – 34,000
- Tridem – 56,400
ROUTINE PERMIT LIMITS
Weight: The maximum weight that can be permitted on each axle is 800 pounds per inch of tire width. This means that four 10-inch tires on an axle would allow a maximum of 32,000 pounds on that axle; four 11-inch tires would allow 35,500 pounds. GVW over 150,000 requires special clearance from DOT.
- Over 100′ – one escort
- Over 120′ – two escorts
- Over 14′ – one escort
- Over 16′ – two escorts
Height: Over 14′ – one escort
Note: According to NJ Statutes, When the vehicle and/or load is over 14′ in height, the permittee shall notify, before the move is made, all Public Utility Companies, NJ DOT, County and Municipal Traffic Engineering Departments.
SIGNS, FLAGS & LIGHTS: “Oversize Load” or “Wide Load” signs required on all overwidth vehicles. Mount red flags on overwidth extremities and the corners of the load, or on the rear corners of an overlength load. Low beam headlights and red tail lights (on both tractor and trailer) should be illuminated.